Shaving tips for a Smooth Finish Shaving is an art, it is not instinctive knowledge, so it is worth printing this page and keeping it. By refining your technique and using good quality products (which need not be expensive) you can make shaving a pleasurable experience. Remember, how you shave affects the way you look and how you feel about yourself. Shaving Technique 1. Hot Water The first essentials to a perfect shave are water and warmth. When hair absorbs hot water it becomes softer and easier to cut and with warmth the skin and facial muscles become relaxed, making shaving so much easier - thus the best time to shave is after a bath or shower. This effect can also be achieved by soaking a folded flannel or small towel in hot water and wrapping it around the face for thirty seconds or more. 2. Preparing the Face Those who desire a particularly smooth shave, (or who have sensitive skin) might wish to apply a glycerine-based Skin Food; this protects the skin and helps the razor to glide smoothly across the face. Massaging the skin food against the growth of the beard also helps to lift the beard in readiness for the lather. 3. The Lather Trumper's shaving cream may be rubbed into the beard with the fingers, but the best results are obtained when using a good quality badger shaving brush. When using cream, place a modest amount in the palm of one hand, dip the brush into hot water and using a circular motion in the palm, build up a rich creamy lather on the brush. Wet the face, and again with a circular motion apply the lather to the beard, allowing the brush to lift the beard, making the hairs stand proud. The brush may be dipped lightly into hot water if more moisture is required in the lather. If using shaving soap, dip the brush in hot water and use a similar circular motion on the soap to create a rich lather. 4. The Shave Using a good blade that has been warmed in the sink or under hot running water, shave the face in the direction of the beard growth, rinsing the blade in hot water frequently. Never shave 'against the grain' of the beard, in awkward areas such as the chin and under the nose the blade can be moved sideways across the growth - but never against as this pulls the skin in the wrong direction causing small cuts and 'grazing' to the skin and is the most common cause of 'razor burn', in-grown hairs and shaving rash. Rinse the face thoroughly with cool water and pat dry with a soft towel. 5. Caring for the Skin A good wet shave exfoliates and cleanses the skin, leaving smooth new skin and a healthy clean appearance. Newly exfoliated skin needs to be protected from the elements, so for healthy skin it is important that men use an after-shaving Moisturiser or Skin Food. Products containing alcohol should not be applied to the skin directly after shaving as this may inflame the skin and cause dryness. For best results cologne and other fragrances should be applied to the 'hot spots' behind the earlobes and on the sides of the neck. General shaving tips Shower or bathe before shaving, or warm the face with a hot flannel. Use plenty of hot water and shave in a warm environment. Protect the skin with skin food or moisturiser. Use a quality badger brush with good shaving cream or soap. Brush in a circular motion to lift the beard. Shave with the beard, never against the grain. Rinse the blade frequently in hot water. Rinse face well with cool water and gently pat dry. After shaving use a moisturiser or skin food. Avoid applying alcohol-based products to the face after shaving. Taking care of your brush and razor After shaving, rinse your brush and razor thoroughly to remove soap and flick to remove most of the water. Brushes are best hung on a brush stand so that water can move away from the base of the hairs. To avoid mildew, do not keep damp brushes in a closed cupboard or washbag for any length of time. If your brush becomes clogged with soap, soak in a mild solution of borax until clean. Wet Shaving - Why Bother? Today many men regard shaving as a daily chore which must be completed as quickly as possible. This is a pity as the benefits of a good traditional wet shave are many. It exfoliates the skin, removing dead skin cells and allows the skin to breathe. The method also provides the closest possible shave with lasting results. However, too often the result of an incorrect shave, is discomfort in the form of razor-burn, rashes and dry-skin. Preparation The key to the perfect shave is preparation. If possible, shave after a shower or apply hot water to the face prior to shaving to soften the beard and open the pores. Although shaving cream may be applied with the fingers, a richer lather is achieved with the use of a good quality shaving brush. The more thorough the lathering process, the better the shave. Use a small amount of shaving cream and rub onto the wet skin by moving the brush in a circular motion and back and forth over the skin, against the grain of the beard to produce good lather. Spend time on the lathering process, up to 2 or 3 minutes. Shaving Always shave with the lie of the beard, never against. Failure to do this is the major cause of razor burn. Glide the razor gently over the skin, holding the skin taut with the free hand whilst shaving. Keep the razor well rinsed to avoid clogging the blade and apply more water if necessary, not more shaving cream. Repeat the process a second time if necessary. After the shave, apply cold water to the face to close the pores and pat the skin dry. In the event of nicks or cuts, apply a moistened Block of Alum to stop the bleeding. Apply a GEO F Trumpers skin food or moisturiser to restore moisture and nourish the skin. Care of the Brush & Razor Rinse and flick dry the shaving brush and razor. Shaving brushes should always be allowed to dry naturally, with the hair pointing downward in a suitable stand, to prevent moisture seeping into the base of the brush. Never store a shaving brush in a closed cupboard where mildew may form
Why You Should Use a Shaving Brush Many of Rich's brushes are still manufactured entirely by hand using techniques that have not changed in over 100 years. The best shaving brushes are still filled with badger hair because of its unique properties. It retains water and is soft to the skin, whilst being tough and durable. A good quality brush will last for many years if properly looked after. The three main features that determine the price of a shaving brush are the size of the handle, the quality of hair used and the density of the fill. There are three grades of badger hair in general use. Pure, Best and Super. Pure, which is dark hair of medium to short length. Best, which is long to medium length, with a paler creamy tip and slightly softer feel. Super, which is longer length hair with a soft creamy white tip. A very limited quantity of Super badger hair is available, making it very expensive. English badger hair is not used in any of the brushes we stock. All badger hair used is sourced as a raw material in China, where the badger is certainly not an endangered or protected species. The hair is then sorted, dressed and sterilised in England.
Technique is Everything Introduction The razor belongs to the oldest tools of mankind. Open razors consist of a blade with tang and a pair of handles. It is drop-forged and hardened with special care. Contrary to pocket knives and household knives, razors are hollow-ground. The more hollow ground the blade, the sharper and more expensive is the razor. The quality of the special steels for razors has continuously been improved and different widths are still being produced. The widths of razors are indicated in inches. The 3/4" razor has the narrowest blade and the 7/8" the widest. The most popular widths in Europe are 4/8" and 5/8" but for a few countries 6/8" and 7/8" are still in demand. The thickness of the back is in proportion to the blade width. A rivet in the tang of the razor holds the handles together and allows the razor to fold. In order to maintain its extreme sharpness, the razor must be honed by hand on a leather strop. Using Leather & Canvas Hanging Strop or Hand-Held Strop. Start with carefully opening and closing your new open razor. If you have never used one before and you can open and close it with your eyes shut without mishap, you are ready to learn how to sharpen it. There is a great art to stropping a razor correctly and much careful practice will be required. You must train intensively before you apply the razor to your skin. Hang the leather strop, securely fixed to the wall at about chest height. Grip the handle firmly and pull out the strop until horizontal without making it absolutely taut or hold the hand strop firmly in a horizontal position with the end resting against solid foundation. First use the leather side of the hanging strop then the canvas side. A small amount of strop paste is applied to the leather side. With the hand strop, first use the wood then the canvas side. A small amount of paste is added to the wood side. Hold the razor in a firm grip with the tang between thumb, first and second fingers of the right hand. The thumb on the near side and the fingers at the back of the tang. Fold the remaining fingers lightly around the handle. Lay the razor flat on the strop, a short distance from the handle with the edge towards you. Holding it flat on the strop, make the first stroke upwards and away from you. At the end of the first stroke, about two-thirds along the strop, raise the edge without lifting the back of the blade off the strop and turn it over till the other face lies flat and make the second stroke upwards and towards you. Turn over again and repeat as before giving each face an n equal number of regular, even strokes. Six strokes to each face are usually sufficient to maintain the edge. Finish with a couple of strokes to the other side of the strop to clean the razor. The razor should now be sharp enough to cut a single hair held vertically. You are now ready to start shaving, having followed the preparations as mentioned in our guide to wet shaving. Wet Shaving using an Open Razor Your skin has been prepared and a good lather has been applied. Hold the razor at an angle of approx. 30 degrees. If you hold the razor too flat it will tear the stubble, too steep and it will cut the skin. The thumb must be placed on the blade itself and not on the tang. The position of the thumb will vary as the different strokes are taken but it must always remain on the blade. Begin on the right side of the face and take the first stroke downward in a slanting stroke from the top of the cheek at the ear, with the razor lying almost flat on the face. The stroke should be made with the blade moving from point to heel in a scythe-like movement without jerks or chopping. The razor must not be pulled or dragged and the skin must always be held taut with the free hand. No stroke should be shorter than 1" of longer than 3". The right side of the face should be wholly shaved according to the diagram before proceeding to the left side. As the chin is approached, lift the razor slightly. Use the middle of the blade for going over the chin. Never begin a fresh stroke on a prominent part of the face, such as the chin or jawbone. Begin a little away from such places and work over with steady strokes. Treat the two sides of the upper lip as part of the face, shaving the right side from nose to face and the left side from face to nose, leaving the centre of the lip to be done separately by holding the nose up slightly to tighten the skin. For the lower lip, the first strokes should be taken across with the skin tightened between the thumb and finger placed under the corners of the mouth. Remove the remaining hairs on the upward stroke, beginning from the chin and allowing the razor to follow the contour under the lip. Having gone over the whole face once, it is usually necessary to go over a second time to ensure a clean shave. The face is lathered again as before but the soap will not require to be worked as long as before. The skin should be held taut in front of the razor and this time the strokes taken as far as possible, against the grain of the hair. After the shave clean the face with cold water and rinse the razor carefully and thoroughly, wiping it on a clean cloth before storage. Apply moisturising balm to the face to soothe and moisturise the skin. Apply moistened alum block to any minor nicks or abrasions. Please Note: These notes on the use of open razors are intended as a guide. Shaving with an open razor is not easy to master and this guide is not to be considered a substitute for being taught by a Barber.
First time over...
Second time over...
Arrows indicate direction and approximate number of strokes. Clear areas indicate freehand strokes and shaded areas backhand strokes. Numbers indicate continuity
Care and Use of Open Razors When examined through a microscope, the edge of a freshly set razor resembles a saw with very fine teeth. To some extent stropping preserves this saw-like edge but in time the teeth get worn down and the razor becomes dull. Setting restores the edge to its former keenness. Rest the hone on a solid flat surface. Open the razor fully out and grip the tang between the thumb and first finger of the right hand. The remaining fingers should loosely encircle the razor handle. Now place the blade flat on the hone at the right hand end. With the edge toward the left and with a firm even pressure, slide it along the hone in a slanting direction, edge first, finishing the first stroke with the point of the razor near the edge of the hone. For the second stroke turn the razor over and begin at the left hand end of the hone with the blade laid flat on, edge to the right hand and the heel of the razor almost touching the edge of the hone. With the same slanting movement, slide the razor toward the right, finishing the second stroke as before with the point of the razor near the edge of the hone. At the end of each stroke always turn the razor over its back, never over its edge. The strokes are repeated right to left, left to right, with equal pressure and movement until the edge is restored. The blade must always be moved along the hone in the correct direction and each face must be given an equal number of strokes. To be able to set a razor quickly and effectively needs patience and much practice. When there is a distinct feeling of the edge gripping the hone wipe the blade carefully and test. Hold up a single hair and place the razor edge smartly against it. If the edge is sufficiently keen the hair will be cleanly severed. Another method is to pass the edge of the razor over a moistened thumbnail. If the edge clings or drags on the nail it is usually sufficiently keen.